Epoxy Flooring in Denver, CO
A single-colour system with a clear coat runs $4 to $6 per square foot and full-broadcast flake with a polyaspartic topcoat $6 to $9, and a two-car garage usually lands between $1,800 and $5,500 installed.
A single-colour system with a clear coat runs $4 to $6 per square foot and full-broadcast flake with a polyaspartic topcoat $6 to $9, and a two-car garage usually lands between $1,800 and $5,500 installed.
Tell us what you need and we route it to local epoxy flooring contractors who do this work. Free, no obligation.
A Denver garage slab works harder than any other floor in the house: summer surface heat, winter ice-melt brine, and a car that parks in the same two spots every night.
A basement floor in Denver is a moisture question before it is a finish question, and the answer is decided by the slab, not by the coating.
A commercial floor is bought in hours of uptime, not in square feet of resin.
Metallic epoxy is a design floor built on an engineering system: the swirl is the topcoat's business, the bond is the slab's.
Polyaspartic is the coating that made the one-day floor possible, and it is the layer that decides how a Denver floor ages under a high-plains sun.
Raw concrete is a working surface, not a finished one, and sealing it is the cheapest way to stop dusting, staining and moisture at the surface.
| Job | Published range |
|---|---|
| Flake system, per sq ft | $4 - $9 |
| Polyaspartic, per sq ft | $6 - $9 |
| Two-car garage, installed | $1,800 - $5,500 |
| Professional install, full range | $4.00 - $15.00 per sq ft |
| Retail DIY kit | $60 - $160 |
| DIY maintenance over 12 years | $720 - $1,920 |
| Repair cost over 12 years, professional system | $0 |
Figures are the published ranges carried over from the source pack, unrounded. Full cost guide.
Denver sits in the Denver metro at roughly 4,500 ft, and the ground under it is not uniform. USDA-NRCS maps the Denver series on the alluvial fans, with a duripan 50 to 100 cm down that holds water, and the Front Range series on the old flood plain, which is poorly drained with a seasonally high water table. Where a slab sits on ground like that, vapour moves up through the concrete even though the air here is dry - average July relative humidity in Denver is around 30%. Add the swing from a 108 F record high to a -16 F record low, and the usual causes of failure are moisture, preparation and thermal cycling rather than the resin brand.
Start with the slab moisture check and the measurement calculator, then run the cost estimator, the system selector and the quote comparison before you call anyone. Twenty tools, no sign-up.
Open all 20 tools → | System advisor